Publicité
ASSEMBLY
- Clean all the removable parts.
- Remove the red silicon part from the bottom of the container (2).
- Mount the container (2) in its seat. To ensure the correct function, press down well the container.
- Fill with water without exceeding the MAX level. Close with the lid (1).
WARNING: Use fresh and natural water, do not use hot or sparkling water, or other liquids.
- Mount the drip container (16) on the front part of housing (6).
- Mount the grid (15) on the drip container (16).
WARNING: Before switch on, verify that all the parts are properly mounted.
FIRST USE and INTERNAL CIRCUIT CLEANING
At the first use it is needed to perform the cleaning of internal water circuits.
Clean coffee circuit
- Insert the plug in the power socket and press button (7) to switch on. The lights of buttons twinkle to
indicate that the appliance is heating, and then they stay on when the appliance is ready.
- Mount the filter holder (21) in its seat (13). Insert the filter holder in correspondence of symbol
rotate clockwise to the symbol .
- Put a 250ml container on the grid (15) and press the 2 cups button (10 -
- Empty the contianer and repeat operation.
Clean steam erogation circuit
- Put a 250ml container under the steam erogator.
- Rotate the knob (3) anti-clockwise and let hot water come out for 30 seconds.
The appliance is now ready to prepare the first coffee.
WARNING: pay attention to not finish all water inside the container during these operations.
WARNING: repeat these operations in case the unit is not used for several days.
OPERATION
Mount the tank (2) in its seat. To ensure correct function, press down well the tank.
Fill the tank (2) with water without exceeding level MAX, then close with the lid(1).
WARNING: Use fresh natural water, do not use hot or sparkling water, or other liquids.
MOUNT FILTER IN THE FILTER HOLDER
The filters are equipped with a safety system that avoids accidental falling of the
filter. To mount and dismount a filter, you have to align the parts identified with A
(filter) and B (filter holder) in the picture on the side.
To mount a filter in the filter holder
-
Take the filter grabbing in correspondence of the part A.
-
Insert in the filter holder (21) the part of filter opposite to the part A.
-
Lower the filter into the filter holder by aligning the parts A and B.
To dismount the filter, align the parts A and B and pull the filter upwards.
THERMOMETER READING
The thermometer measures the temperature of the water inside the boiler. The colors on the dial are:
-
Yellow: heating phase
-
Green: optimum temperature for espresso and hot water erogation
-
Blue: optimum temperature for steam erogation
MAKE COFFEE WITH POWDER
- Insert the plug in the power socket and press button (7) to switch on. The lights of
buttons twinkle to indicate that the appliance is heating, and then they stay on when
the appliance is ready.
- Select the desired filter, one or two cups (18 or 19), and insert in the filter holder (21).
).
and
15
Publicité
