Publicité
Confiden�al
Installa�on Place
You must follow the instruc�ons below:
The floor on which the product will be installed must be capable of bearing 1,200 pounds (544 kg)minimum.
Kitchen floor and the bo�om of the product must be at the same level. Otherwise, problems may occur with
the air suc�on of the product.
There must be no objects preven�ng the installa�on of the product at the back and on the side walls of the
product's installa�on place.
The power socket must be at the correct place.
Dimensions of the furniture where the product will be installed must be in strict conformity with the
dimensions given in the manual.
Do not install the product with the fridge and the freezer are adherent next to each other. Otherwise,
condensa�on and damage may occur in the product. (Please see "Dual Cabin Installa�on" for detailed
informa�on)
Flatness of the floor where the product will be installed must be checked with a Bubble Level Tool.
Installa�on area must not be subjected to direct sunlight and it must be away from heat sources, ovens,
radiators etc.
The ambient temperature must be between 55°F (13°C) and 110°F (43°C). Otherwise,
func�on errors may arise when the product is running.
If it is not possible to avoid installing the product near a heat source, the minimum clearances given below must
be maintained between the product and the said source:
11/4" (3 cm) from electric hobs or ovens 1 1/4
12" (30 cm) from gas or fuel operated hobs orovens
Please observe the following rules:
The power socket or fuse must be easily accessible in case of an emergency;
it must not be hidden behind the product.
Plug or cable must not touch the back surface of the product. Otherwise,
it may get damaged due to the vibra�on of the product.
Do not connect the plugs of other appliances behind this product.
If the humidity level is high where the product is used, corrosion may be seen
on the outer surface of the product.
Keep the installa�on room dry and well cleaned to avoid corrosion.
7
WWW.KUCHT.COM
Publicité
