S-9602-P
Tub/Shower System
Specification Submittal
Specification
Tub/shower system powered by the Temptrol
Balancing valve with integral diverter. Tub/shower system
shall include adjustable stop screw to limit handle turn,
non-diverter tub spout, 1 mode showerhead with easy to
clean rubber nozzles and standard 2.5 gpm (9.5 L/min)
flow restrictor. Components shall be made from metal
and nonmetallic construction, plated in standard
polished chrome finish.
Model Numbers
S-9602-P
Origins tub/shower system
S-9602-P-TRM
Origins tub/shower, trim only
S-46-2-BODY
Temptrol Pressure Balancing tub/shower valve body
S-46-2X-BODY
Temptrol Pressure Balancing tub/shower valve body
with stops
Compliance
-ASME A112.18.1/CSA B125.1
-WaterSense 1.5 gpm (5.7 L/min)
2.0 gpm (7.6 L/min)
Warranty
Limited Lifetime - to the original end purchaser in
consumer/residential installations.
5 Years - for industrial/commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Location:
Origins
®
Modifications
Pressure
®
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
☐
Certi ed by
CSA Group
Note: Append appropriate -suffix to model number.
CG
-1.5 1.5 gpm (5.7 L/min) flow restrictor
-2.0 2.0 gpm (7.6 L/min) flow restrictor
-143 3 mode showerhead in place of standard head
-145 5 mode showerhead in place of standard head
-231 Super showerhead in place of standard head
-295 Institutional showerhead (chrome only)
-B Brass escutcheon (chrome only)
-CHKS Integral check stops - for use in installations
where a positive shut-off device is used
downstream of mixing valve
-D Brass dome cover (chrome only)
-IPS 1/2" female IPS connections
-LAM Lever handle
-LP Loop handle
-L/HD Less showerhead
-REB Rebuild trim kit, includes TA-10 and TA-4
-REV Reverse coring, hot on right, cold on left, for
back to back installations
-SS Slip spout on any tub/shower unit
-VP Vandal resistant escutcheon screws in place of
standard screws
-X Integral service stops - allows water shutoff at
valve for service