Due to shock hazard and to prevent accidental water leaks, this inspection
should be done by a qualified servicer or plumber, and requires that the
electric power and cold water supply be turned off before servicing the anode
rod.
Note: Do not remove the anode rod from an operating water heater. Operating
the water heater without the anode rod will shorten the life of the tank and
VOID the warranty.
The anode rod should be inspected after a maximum of three years and
annually thereafter until the condition of the anode rod dictates its
replacement.
Note: Artificially softened water requires the anode rod to be inspected
annually.
Anode Rod Maintenance and Service
Caution - important safety notice
This information is intended for use by individuals possessing adequate
background of electrical, electronic and mechanical experience. Any attempt to
repair a major appliance may result in personal injury and property damage.
The manufacturer or seller cannot be responsible for the interpretation of this
information, nor can it assume any liability in connection with its use.
Tools needed:
• Socket/Torque Wrench
• 1 1/16" Socket
• Pipe joint compound or Pipe sealant tape
• Anode Rod, if needed
*See Parts List in this manual for parts location instructions
To Inspect and Replace the Anode Rod:
1. Turn off power and shut off the water supply to the water heater.
2. Open a nearby hot water faucet to depressurize the water tank. Drain the
water heater.
3. Use a 1 1/16" socket to unscrew the anode rod and lift it out.
4. Inspect the anode rod and replace it if necessary.
5. To replace the anode rod, remove old anode rod. Use pipe joint compound
or pipe sealant on threads and install new anode rod.
6. Turn on water supply and open a nearby hot water faucet to remove any air
in plumbing system, fill the water heater tank with water, check for any leaks
and immediately correct if any found, then turn the power on.
Note: Do not turn on power until water heater is completely filled with water.
8350 Patriot Blvd STE B, North Charleston, SC 29418
support@thermomate.com
12