Publicité
USING THE TELESCOPING WAND
WARNING:
The telescoping wand will flex as pressure is added or lost. Fully understand how the wand moves
when adding or lessening pressure before attempting a cleaning project. If you are not completely
comfortable with the movement of the wand under changing pressure conditions, do not use this
product. Loss of control of the telescoping wand could result in possible serious personal injury.
6. Adjust the height of the telescoping wand as needed to fit your project requirements.
WARNING:
Lengthen the telescoping wand only as much as necessary for the project you are attempting and
remain in full control of the telescoping wand at all times. Loss of control of the telescoping wand
could result in possible serious personal injury.
7. Move to the project area, raise the wand and aim toward the area to be cleaned. Squeeze the
trigger to begin spraying.
8. When placing the wand on the ground, make sure to set it on the ground gently to avoid breaking
any of the plastic components or accessories.
CARE AND MAINTENANCE
De-pressurize by squeezing the gun trigger until all of the water has been drained out of the unit.
TROUBLESHOOTING
PROBLEM
Connections leak.
Unit won't spray.
Wand section will not
stay in place.
WARRANTY
TWO YEARS LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for two (2)
years from date of purchase. If within this period a product is found to be defective in material or
workmanship, the product must be returned with a copy of the bill of sale as proof of purchase to
the manufacturer. This warranty does not cover the product becoming defective due to misuse,
accidental damage, improper handing and/or installation and specifically excludes liability for direct,
incidental or consequential damages. As some states do not allow exclusions or limitations on how
long an implied warranty lasts, the above exclusions and limitations may not apply to you. This
warranty gives you specific rights and you may also have other rights which vary from state to state.
For warranty service, call +1 (866) 870-9930, 9 a.m. - 5 p.m., EST, Monday - Friday.
POSSIBLE CAUSE
1. Loose connections.
2. Sealant worn.
3. O-ring is worn.
1. Unit power / water supply off. 1. Consult owner's manual.
2. Unit is clogged.
1. Lever lock is loose.
2. lever lock is broken.
CORRECTIVE ACTION
1. Retighten fittings.
2. Reapply pipe tape.
3. Replace O-ring.
2. Reverse flush unit with water.
1. Try tightening the hex screw
on the lock lever.
2. Replace lever lock.
8
Printed in China
www.surfacemaxx.com
Publicité
