Publicité
Important Information
WARNING: When using electrical products, basic precautions should
always be followed, including the following:
WARNING: Risk of electric shock. A qualified electrician should route all
electrical wiring.
WARNING: Risk of electric shock. Disconnect the power before servicing.
CAUTION: Risk of product damage. The amplifier is rated to operate in
temperatures up to 104°F (40°C). Do not install near heat sources (such as
radiators or heat registers) or in any location where the temperature may
exceed 104°F (40°C).
NOTICE: This product is not water-resistant. Do not install in a location where
excessive moisture, high humidity levels, or condensation are present.
NOTICE: Provide unrestricted service access to the amplifier.
NOTICE: Provide a minimum of 6" (152 mm) of space around the amplifier for
proper air flow.
NOTICE: Follow all local plumbing, building, and electrical codes.
NOTE: This amplifier can be operated as a stand-alone unit, or can be installed with
the Anthem
+ showering system.
TM
Operation with Anthem+
To connect the amplifier to the Anthem+ system, the K-27756-NA system controller is
required.
The provided data cable is used to connect the amplifier to the system controller.
Refer to the "Anthem+ System Layout" section in this guide.
Before Operating the Anthem+ System For the First Time:
Download and install the latest software for connected components. This may take an
hour or more to complete based on system configuration and internet connection
speed. Do not disconnect the power from any components during software
download and installation.
Kohler Co.
3
1585746-2-A
Publicité
