Publicité
Wireless Input
Once a BLUETOOTH device is connected, the LED will blink blue.
The amplifier will display on the device as "Kohler Amplifier."
If a BLUETOOTH pin is required, enter "0000."
NOTE: If connected to an Anthem+ system, the pin and device name can be changed
using the Anthem+ system controller embedded setup page.
Upon receiving a wireless signal, the LED will turn solid blue and the audio input
will fade in.
Wireless input will override any signal that may be coming from the front or back
line-in ports.
RCA Output
A line-out port is available to provide unamplified stereo output of the audio
signal that can be fed to another external device.
Standby Mode
If no audio signal is detected for 30 seconds from the RCA inputs, the amplifier
will go into standby mode and the LED will turn yellow.
BLUETOOTH Standby: If no audio signal is detected for 30 seconds from a
connected wireless device, the amplifier will go into BLUETOOTH standby mode
and the LED will change from solid blue to blue blink.
Anthem+ Operation
For information on operating the amplifier using the Anthem+ system, refer to the
guide on the K-27756-NA controller product page at kohler.com.
Kohler Co.
13
1585746-2-A
Publicité
