Publicité
the best code.
Remarks:
a. Whenever you want to leave or change search mode, press the device key to quit, and the LED
will turn off.
b. You may use the SET key to change the search direction from forward to backward or from
backward to forward.
C. Set up by Auto Search:
This search is similar to Manuel Search except it transmits power signal automatica-
lly instead of manually pressing the power key during the search:
a. Power on the device you want to control.
b. Press and hold [SET] key, in the meantime, press and hold the Device key
that you want to control. (for example: TV) for more than 3 seconds and then
release them, the auto search begins. The remote control enters into Auto
Search, LED flash, and remote control transmit power signal every 2.0 second
automatically.
c. See if device react or not, once the device reacts, press any key (except SET
key) to stop the search.
d. Test if other keys work well enough. If most keys work not good enough, Auto
Search again to find next reactive code and try until you find the best code.
Remark:
a. You must point your remote control to the device that you want to control during Auto Search.
b. Whenever you want to leave Auto Search mode, press any key (except SET key) to quit, and
the LED will be
Off. The search is over.
c. When remote control search through all codes (about 10 minutes), then the remote control will
quit from Auto Search process automatically.
d. In case of you did not stop the search on time when device reacted, you may use the Manual
Search to search back to find the passed code.
Volume and Mute Lock/Unlock:
a. Strike the device key that the volume and mute key you want to fix such as
[TV], [TDT]etc
b. Press and hold the [SET] key, then press the [5] key, then release the both
pressed keys, the LED will blink twice then off, the volume and mute key of the
current device are locked.
c. If you want unlock the current volume and mute key, press and hold the [SET]
key, Then press the [6] key, then release the pressed keys, the LED will blink
twice and then off, the current volume key and mute key are unlocked.
Device Lock/Unlock
You can use "Device Lock" function to fix current device code and this device code
cannot be changed by code set up or code search. You can use the "Unlock" to quit
from this function.
a. Strike the device key that you want to fix such as [TV], [TDT], etc
b. Press and hold the [SET] key, then press the [7] key, then release the both
pressed keys, the LED will blink twice then off, the code of the current device
are locked.
Publicité
