Hilti TE 500-A36 Mode D'emploi page 23

All manuals and user guides at all-guides.com
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise emission values in accordance with EN 60745
Sound pressure level (LpA)
Uncertainty for the sound pressure level (KpA)
Sound power level (LWA)
Uncertainty for the sound power level (KWA)
Total vibration in accordance with EN 62841
Uncertainty (K)
Chiseling in concrete (a
Uncertainty (K)
5 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
6 Operation
6.1 Preparations at the workplace
Switch the product off or remove the battery before making adjustments or changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6.1.1 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
6.1.2 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
6.1.3 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
*2240495*
Printed: 16.07.2019 | Doc-Nr: PUB / 5503655 / 000 / 00
)
h, CHeq
2240495
TE 500-A36
89 dB
3 dB
100 dB
3 dB
TE 500-A36
1.5 m/s²
6.7 m/s²
1.5 m/s²
36 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
English 19