Publicité
Federal Communications Commission
Pursuant to part 15.21 of the FCC Rules, you
are cautioned that changes or modifications not
expressly approved by the party responsible for
compliance could void your authority to operate the
product.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules
and ISED-Canada's license exempt RSS standards.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference,
and 2) This device must accept any interference
received, including interference that may cause
undesired operation.
SYMBOLOGY
Volts
Direct Current
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
Read Operator's Manual
Power Button
Rotational Speed Button
Sweep Button
Leveling Mode Button
Pair Button
Bump Alarm LED
Y-Axis Indicator
Coin Cell Polarity Indicator
SPECIFICATIONS
Cat. No. ..................................................... 3702-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
Module/FCC ID ............................ BGM11S/QOQ11
Coin Cell Battery Type ............................... CR2032
Laser............................................................Class 2
Max Power.......................................... P
Wavelength........................................ 510 - 530 nm
Beam Divergence ................................... <1.5 mrad
Rotational Speed ....................300, 600, 1200 RPM
Sweep Angles ................................0°, 10°, 45°, 90°
Single Slope Axis Range ..........................±6° (min)
Leveling Range......................... 12° in X and Y Axis
Working Range .............................1000' (Diameter)
Horizontal Plane Accuracy..... ±1/16" at 100' (0° tilt)
Vertical Plane Accuracy ........... ±1/8" at 100' (0° tilt)
Plumb Point Accuracy.............. ±1/8" at 100' (0° tilt)
Altitude..........................................................<6560'
Pollution Degree ....................................................2
Typical Leveling Time ...................... <12 (Seconds)
Travel Startup Time @ 8° ................ <40 (Seconds)
Mounting Insert ............................................ 5/8"-11
Ingress Protection (Tool Only) ......................... IP66
Drop ................................................................1.5 m
Tip Rating ..........................................................2 m
Bare Tool Weight .............................................8 lbs
Weight .............................................................9 lbs
(With M18 XC™ 3.0 battery pack)
Maximum Relative Humidity (RH) ................... 80%
Decreasing Linearly Relative Humidity (RH) ....50%
Lanyard................MILWAUKEE Energy Absorbing*
Recommended Ambient
Storage Temperature .................... -13°F to 140°F
Operating Temperature .................... 0°F to 122°F
Recommended Compatible
Remote/Receiver Cat. No. ......................... 3712
NOTE: Accuracies and leveling times are measured
on a level surface at ambient temperatures. Use of
the tool in extreme conditions may negatively impact
these specs.
*Lanyards sold separately
3
BL654/SQGBL654
CAN ICES-003(B)/NMB-003(B)
AVG
(With Remote/Receiver)
for up to 88°F
≤ 1 mW
at 104°F
Publicité
