Installation instructions
•
Ensure that the heater is properly installed before use�
•
The heater should always be installed horizontally and should only
use the mounting brackets provided�
TOOLS NEEDED FOR INSTALLATION
•
3/16" drill bit
•
Philips screwdriver
HEATER LOCATION (wall & ceiling mount)
When choosing a location for your new heater, ensure that the general
instructions are followed�
•
Your heater must be installed on a provided mount or tripod�
•
The heater should not face the ceiling or flammable substances.
•
Ensure that there is no possibility of flammable material coming
into contact with the heater or lying near the heater�
•
This heater is weather resistant and can be used indoors or
outdoors� If using outdoors, use a waterproof outlet�
Cold climate installation note
Placing the unit under a window or on a poorly insulated wall may result
in the heater reading a colder ambient temperature than the actual
room temperature�
DO NOT USE in the following areas:
•
Locations with gasoline, paint, or flammable liquids
•
Wet or moist locations
•
Closets
•
Do not use directly near a bathtub, a shower, a swimming pool
POWER CONNECTION GUIDELINES
Heat Storm Heaters are classified as appliances. Each heater and
appliance should have its own dedicated circuit�
This heater is designed for standard 120-volt, 20-amp outlets and
should only be connected to a properly grounded outlet� Plug the
heater directly into a wall outlet with the cord fully unwound; do not
use extension cords, surge protectors, or relocatable power taps� Do not
use this heater with a timer device that automatically turns it on while
unattended (e�g�, Alexa or Google programmed plug)�