Publicité
PARTS AND FEATURES
1.GLASS DOOR
2.LAMP SWITCH
3.USER INTERFACE
4.CABINET
5.CHROME/WOODEN RACK
6.CHROME/WOODEN RACK
7.FOOT
8. LED
The most energy-saving configuration
requires drawers, food box and shelves to be
positioned in the product, please refer to the
above pictures.
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
• Remove the exterior and interior packing,
including protective material.
• Check if the components or accessories are
completed and in good condition.
• Before connecting the appliance to the
power source, let it stand upright for
approximately 2 hours. This will reduce the
possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm
water using a soft cloth.
Installation of Your Wine Cooler
• Place your appliance on a floor that is strong
enough to support the appliance when it is
fully loaded. To level your appliance, adjust
the legs at the front of the appliance.
• Allow 5 inches of space between the back
and sides of the appliance, which allows the
proper air circulation to cool the
compressor.
• Locate the appliance away from direct
sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may
increase electrical consumption.
• Extreme cold ambient temperatures may
also cause the appliance not to perform
properly.
• Avoid locating the appliance in moist areas.
Too much moisture in the air will cause frost
to form quickly on the evaporator.
• Plug the appliance into an exclusive properly
installed-grounded wall outlet. Do not under
any circumstances cut or remove the third
(ground) prong from the power cord.
• Any questions concerning power and or
grounding should be directed toward a
certified electrician or an authorized
products service center.
Warning: Improper use of the grounded plug
can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by
an authorized products service center.
EXTERNAL HANDLE
If the external handle is presented in the
product, follow the below steps for assembly.
25
Publicité
