Publicité
Note:
Do not mix fuel and oil in the fuel tank. Oil at
room temperature mixes easier and more thoroughly
than cold oil. Oil below 0°C (32°F) requires additional
mixing.
Using Stabilizer/Conditioner
Use fuel stabilizer/conditioner in the machine to keep
the fuel fresh longer when used as directed by the
fuel-stabilizer manufacturer.
Important:
Do not use fuel additives containing
methanol or ethanol.
Add the amount of fuel stabilizer/conditioner to fresh
fuel as directed by the fuel-stabilizer manufacturer.
Filling the Fuel Tank
Fuel-tank capacity: 1.1 L (36 fl oz)
Refer to your engine owner's manual for additional
information.
Fill the fuel tank as shown in
Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
(page
15).
Removing and Installing
the Tines
1.
Park the machine on a level surface, shut off the
engine, and allow the engine to cool.
2.
Remove the hairpin cotter from each end of the
tine shaft.
All manuals and user guides at all-guides.com
Figure
8.
Figure 8
Maintenance
1. Hairpin cotter
3.
Slide the tines off the shaft.
4.
Slide the inner tines ("B" and "C") on the shaft.
Note:
The letters are stamped on the tines.
Slide tine "B" on the left side of the shaft, and
slide tine "C" to the right side of the shaft.
g230458
5.
Slide the outer tines ("A" and "D") on the shaft,
so that the order of the tines is "A", "B", "C", "D",
when viewed from the operating position.
Note:
Ensure that the hub collars on both the
left and right pairs of tines face each other to
ensure adequate spacing between the tine
blades.
10
Figure 9
Figure 10
g334235
g334237
Publicité
