Télécharger Imprimer la page

SIGNIFY LIGHTOLIER ModuLyte 4in Mode D'emploi

Publicité

Liens rapides

CAUTION: THE INSTALLATION AND SERVICING OF THIS PRODUCT MUST BE PERFORMED BY A
QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital service, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, many cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
Read and understand these instructions before installing luminaire (fixture)
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before installation.
WARNING – To prevent electrical shock, turn off electricity at fuse box before proceeding. Allow fixture to cool
before handling.
Retain these instructions for maintenance reference
ModuLyte accepts Light Engines:
• M4RDL, M6RDL & M8RDL
5/14/2024
page
1
Parts
Light Engine
Reflector
Downlighting
IS M_RLW
ModuLyte 4in, 6in & 8in
Caution (RISK OF FIRE)
Use only with ModuLyte LED light engines and reflector.
WARNING – Make sure that the power supply is
disconnected before installation.
Trim Springs
Wallwashkit
442296472131
CAN ICES-005 (A) / NMB-005 (A)
www.lightolier.com

Publicité

loading

Sommaire des Matières pour SIGNIFY LIGHTOLIER ModuLyte 4in

  • Page 1 Downlighting IS M_RLW 442296472131 ModuLyte 4in, 6in & 8in CAUTION: THE INSTALLATION AND SERVICING OF THIS PRODUCT MUST BE PERFORMED BY A QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL NOTE: This equipment has been tested and found to comply with the limits for a Class A digital service, pursuant to Part 15 of the FCC Rules.
  • Page 2 IS-442296472131 IS M_RLW Step 1 Step 2 To replace the media holder rotate it counterclockwise Center the 3 openings of the wallwashkit with the 3 tabs until it is no longer tightened and pull it off downwards of the luminaire and insert it (Figure 2 and 3). (Figure 1).
  • Page 3 Éclairage vers le bas IS M_RLW 442296472131 ModuLyte 4in, 6in & 8in ATTENTION : L'INSTALLATION ET L'ENTRETIEN DE CE PRODUIT DOIVENT ÊTRE EFFECTUÉS PAR UN ÉLECTRICIEN QUALIFIÉ OU UN PERSONNEL D'ENTRETIEN. REMARQUE : Cet équipement a été testé et jugé conforme aux limites s'appliquant aux appareils numériques de catégorie A, en vertu de la partie 15 des règlements de la FCC.
  • Page 4 IS-442296472131 IS M_RLW Étape 1 Étape 2 Tournez le porte-support de média dans le sens Centrer les 3 ouvertures du wallwashkit avec les 3 antihoraire jusqu'à ce qu'il ne soit plus serré et tirez-le languettes du luminaire et l'insérer. vers le bas pour le retirer (Figure 1). Remarque: Pour un retrait facile, utilisez les embouts de support.

Ce manuel est également adapté pour:

Lightolier modulyte 6inLightolier modulyte 8in