Publicité
GO series microphones - Lavalier, headband or handheld UHF systems
3 - Installation
3.1 - Connecting the receiver
AUDIO OUTPUT
UNBALANCED
BALANCED
AUDIO OUTPUT
UNBALANCED
LINE MIC
BALANCED
BALANCED OR
UNBALANCED CABLE
MIXING DESK
AMPLIFIER
AUDIO OUTPUT
UNBALANCED
BALANCED
DC INPUT
12V 500mA
CHANNEL
SQ
LINE MIC
5
1
9
13
DC INPUT
12V 500mA
CHANNEL
SQ
5
1
9
13
AC ADAPTER
LINE
DC INPUT
12V 500mA
CHANNEL
SQ
LINE MIC
5
1
9
13
- Connect the supplied AC adapter to
an electrical outlet, and to the DC
12V socket located at the rear of the
GOMono receiver.
- Connect the audio output to your
mixing desk with either a balanced
XLR cable or unbalanced Jack 6.35.
- Do not use both the unbalanced and
balanced outputs simultaneously
as it might cause signal losses and
increases parasitic noises.
- In order to preserve a good sound
quality and prevent distortions, you
can adjust the volume by following the
instructions below:
- If you are using a microphone input of
your mixing desk or amplifier, turn the
volume to half power (approximately),
the balanced and unbalanced outputs
level will then be close to 77 mV.
- If you are using a line level input of
your mixing desk or amplifier, turn the
volume to 3/4 of the maximum power,
the unbalanced and balanced outputs
SPEAKER
will then be close to 770 mV.
MIC
- Adjust the output level to the input
level used by the mixing desk.
- MIC level: - 20dBm
- LINE level: 0 dB
English
Page 19
Publicité
