Publicité
AA
5
Installing the tip restraint hardware
When the Tipping Restraint
•
Hardware (AA) is properly installed,
it can provide protection against
unexpected tipping of the Unit due
to small tremors, bumps or climbing.
• Each Tipping Restraint Hardware
(AA) includes one Unit Anchor, one
Wall Anchor, one Anchor Tether, and
two Anchor Screws. Use these to
complete the following steps for a
proper installation.
• Locate a secure wall stud behind the
unit closest to left side.
• Align the Unit Anchor with a wall
stud and attach to the Unit with
two Anchor Screws using a Philips
screwdriver. The Anchor Screws must
pass through the Top Assembly for
proper installation.
• Align the Wall Anchor in the center of the wall stud, at level with the Unit Anchor, and
with two Anchor Screws using a Philips screwdriver.
• On the Anchor Tether, detach the cable from the connector and loop the loose
cable through the eyelets on the Wall Anchor and Unit Anchor. Reattach the loose
cable to the connector, but do not tighten.
• Locate a secure wall stud behind the Unit closest to the right side and repeat the
steps above.
• Tighten both Anchor Tethers by pulling the cable through the connector.
NOTE: Installation of the Tipping Restraint Hardware (AA) will provide a small space
between the wall and the Unit. This will allow you to run power cords and connector
cables to your television or other devices placed on top of the Unit.
Warning: You must install the tip restraint hardware to help prevent any accidents or
damage to the unit. We strongly recommend attaching the tip restraint hardware to a
wall stud and your unit. For all other wall types, please visit your local hardware store
to obtain the proper hardware.
HARDWARE/QUINCAILLERIE/FERRETERÍA
[x2]
Wall Stud
Poteau Mural
Montante De
Madera
11
PH-BKTSLV016
42MM71557EU REV1.0
Publicité
