Jacob Delafon EVOK EXCELLENCE Notice D'installation page 16

Drilling for taps
Once you have decided where to place the taps :
- Locate and mark the spot to be drilled
- Check under rim to ensure that there is ample room for the tap and that no other components are in the way
- Protect bath with adhesive tape
- Using a crown saw, drill from above on the acrylic side.
Install the tap on the acrylic bath, following manufacturer's instructions.
Waste
Install waste use protective, waterproof sealing (follow manufacturer's instructions).
Installing the waterfall headrest
1 6
Place foam rings (supplied in instructions pack)
over threaded ends on the smooth side of the bath.
Insert waterfall unit into both holes (pre-drilled on the bath).
Place a 1/2 rubber seal on the connector fixed to the bath.
Attach the nut to the 1/2 connector on the waterfall,
tighten with key (not supplied).
All manuals and user guides at all-guides.com
X1
(optional on the PLUS and LUXE systems)
X2
Apply silicon seal around both threaded ends,
on the support side of the bath (not smooth).
Place both lock nuts and tighten with key (not
supplied).
X1
X2