Preparing For Use; Tips For Use; Use; Manually Adjustable Sections - Auping AVS 433 Mode D'emploi

3.4 Preparing for use

Check that the mesh base can move freely.
Only adjust the mesh base while it is in a
horizontal position, securely fixed to the
supporting legs, or to the supports provided
within the bed surround.
Check that the mattress is attached to the
mesh base properly.

3.5 Tips for use

A new mattress has a certain amount of
rigidity, which will disappear within a few days.
Consequently, your mattress will not optimally
follow the contours of the mesh base when it
is initially adjusted. We therefore recom mend
that you lie down on the mattress while
adjusting the positions for the first time.
_01G4Q_3392 AVS 433 bw.pdf - pag.15

4. Use

4.1 Manually adjustable sections

Raise back section
Pull the adjustment cord and lean forward with
the upper part of your body. The back section
will then move up automatically. Release the
cord when you reach the position you want.
Lower back section
Pull the adjustment cord and lean backwards.
The back section will go down. Release the
cord when you reach the position you want.
If necessary, you can adjust the power of the
gas spring yourself (see 4.3).
Foot end
The foot end has six adjustable positions.
Carefully pull on the handle until the desired
position is reached.
To put the foot end into a lower position you
must first pull it up as far as it will go and then
lower it again.
4.2 Setting the Comfortslides
The mesh base can be adapted to the shape
of your body. The slides are incorporated in
the mesh base at both shoulder and hip level.
Remove the mattress from the mesh base.
The illustrations of the various positions of the
Comfortslides
of course set the slides to the position you
consider the most comfortable.
Lift the slides slightly, then slide them to the
desired positions.
Replace the mattress on the mesh base.
LET OP !!! Lage resolutie!
®
® are examples only. You can
GB15
June 3, 2008