Publicité
SET UP
SODASTREAM
Please note that ensō
TM/MC
compatible with the Sodastream CO
Quick Connect Cylinder and is NOT
compatible with the SodaStream® CO
Screw System Cylinder or other cylinders.
INSTALLING THE CO
QUICK CONNECT CYLINDER
1.
Place ensō
Sparkling Water Maker on a flat sturdy
TM/MC
surface.
2.
Gently pull the plastic carbonating bottle towards you
until it reaches its fully forward position. This will allow
the plastic carbonating bottle to be released from the
Snap-Lock.
3.
Remove seal and cap from the SodaStream CO
Quick Connect Cylinder. WARNING! Never insert or
replace the CO Quick Connect Cylinder while a
Carbonating Bottle is installed in the Sparkling
Water Maker. This can cause the Carbonating
Bottle to be ejected or burst.
4.
Raise the cylinder handle.
5.
Open the cylinder compartment.
6.
insert the CO Quick Connect Cylinder into the cylinder
compartment of the Sparkling Water Maker.
7.
Close the cylinder compartment.
8.
Lower the cylinder Handle.
9.
Place the drip tray on the base of your Sparkling
Water Maker.
Now you are ready to create the bubbles.
CREATE THE BUBBLES
ONLY COMPATIBLE WITH THE FOLLOWING PLASTIC BOTTLES:
Check for compatibility on the bottle pack.
1.
Fill the plastic carbonating bottle with cold water up to
the fill line. WARNING! Do not carbonate anything
other than water. Other liquids can contaminate and
clog internal parts, potentially resulting in excessive
pressure, bottle failure during carbonation and
serious injury. Never carbonate after flavoring has
been added.
2.
To insert the plastic carbonating bottle make sure that
the bottle rest is angled forward. Please make sure you
do not pull the carbonating tube. WARNING! Never
use a Sparkling Water Maker with a broken
carbonating tube. This can cause excessive pressure,
bottle failure and serious injury. Insert the Plastic
Carbonating Bottle neck into the Snap-Lock system.
Push the Plastic Carbonating Bottle up and back. The
Snap-Lock will hold the Plastic Carbonating Bottle.
CO QUICK CONNECT CYLINDER
®
is only
COMPATIBLE SODASTREAM
CO QUICK CONNECT CYLINDER
2
A
B
5
8
1
Note: When inserted correctly, there is a small gap between
the bottom of the Plastic Carbonating Bottle and the base.
Do not carbonate if the Plastic Carbonating Bottle is resting
on the base, or water will splash out.
NON COMPATIBLE
CO SCREW SYSTEM CYLINDER
A
3
B
6
9
1L
0.5L
1L
SodaStream
plastic carbonating bottles
®
2
A
4
7
1L
B
2
Publicité
