Publicité
CYCLE SETTING BUTTONS
SENSOR DRY cycles have preset settings
that are selected automatically. MANUAL DRY
cycles have default settings, but you may also
customize the settings using the cycle setting
buttons. Press the button for that option to
view and select other settings.
NOTE: To protect your garments, not every
dryness level, temperature, or option is
available with every cycle. See the Cycle
Guide for details.
DRY LEVEL
Selects the level of dryness for
the cycle. Press the DRY LEVEL
button repeatedly to scroll through
available settings.
• This option is only available with SENSOR
DRY cycles.
• The dryer will automatically adjust the cycle
time. Selecting VERY DRY or MORE DRY
will increase the cycle time, while LESS
DRY or DAMP DRY will decrease the cycle
time.
• Use a LESS DRY or DAMP DRY setting for
items that you wish to iron.
TEMP. CONTROL
Adjusts the temperature setting
from ULTRA LOW to HIGH. This
allows precise care of your fabrics
and garments. Press the TEMP.
CONTROL button repeatedly to scroll through
available settings.
TIME DRY
Allows you to manually select the
drying time, from 20 to 60 minutes,
in 10-minute increments. Use
this for small loads or to remove
wrinkles. Use the MORE TIME/LESS TIME
buttons to add or reduce the drying time in
1-minute increments.
SIGNAL
Adjusts the volume of the end-of-
cycle signal, or turns off the signal.
32
All manuals and user guides at all-guides.com
Your dryer features several additional cycle
options to customize cycles to meet your
individual needs. Certain option buttons also
feature a special function (see the following page
for details) that can be activated by pressing and
holding that option button for 3 seconds.
To Add Cycle Options to a Cycle:
Turn on the dryer and turn the cycle selector
1
knob to select the desired cycle.
2
Use the cycle settings buttons to adjust the
settings for that cycle.
3
Press the cycle option button(s) for the
option you would like to add. A confirmation
message will be shown in the display.
4
Press the START/PAUSE button to start the
cycle. The dryer will start automatically.
WRINkLE CARE
Selecting this option will tumble the
load periodically for up to 3 hours
after the selected cycle, or until
the door is opened. This is helpful in preventing
wrinkles when you are unable to immediately
remove items from the dryer.
DAMP DRY SIGNAL
With this option, the dryer
will signal when the load is
approximately 80% dry. This
allows you to remove faster- drying lightweight
items or items that you would like to iron or hang
while still slightly damp.
Publicité
