Publicité
plug, have the plug replaced with a suitable model by a qualified professional, who should
ensure that the cord is suitable for the power rating of the appliance (10A). Check that other
appliances with high absorption are not connected to the power line to avoid overloading
and fire hazards. The use of adaptors or extensions is generally not advisable; if it is
necessary to use them, they must comply with safety regulations and the total current (amps)
must not be rated lower than the maximum current of the appliance.
• Before each use, check that the appliance is in good condition and that the power cord is not
damaged: if in doubt consult a qualified professional.
• Ensure that the power cord is correctly positioned and does not come into contact with hot
parts or sharp edges, or become wound around the appliance itself and is not twisted.
• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or explosive objects (spray cans) and from materials
that can be deformed by heat. Make sure there is 120 cm of free space in front of the fan
heater and 100cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves),
level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use: run the appliance to eliminate the "new smell" and any oil residue from the
manufacturing process for at least 10/15 minutes. During this operation, ventilate the room
well to eliminate the "new smell" that is given off by the appliance.
The appliance comes with a thermostat, selector switch and safety device:
- the selector switch controls the following:
"0" = off; "
"= fan on; "
- the thermostat adjusts the ambient temperature, and is greater when the selector is turned
towards the maximum position (clockwise direction): once the temperature has been
reached, it will be kept constant, while setting it to the lines in between causes the element
to come on at intervals.
- safety device: when included it stops operation in the event of overheating. To restore
operation, remove the plug from the mains and wait for it to cool (about 20 minutes) and
insert the plug into the plug point and turn on again.
To use the fan heater, proceed as follows:
1)
Plug into the socket.
2)
Adjust the thermostat knob to the required ambient temperature.
3)
Turn the appliance on by turning selector switch clockwise to the required setting.
4)
The heating unit can be turned to direct air flow in multiple directions and blocks
automatically. To position it use handle (D).
5)
To turn the appliance off, turn the adjustable thermostat in pos.min, selector switch to "0"
and remove the plug from the mains.
If the appliance is not being used for long periods of time, remove the plug from the plug point.
CLEANING AND MAINTENANCE
Warning: before cleaning the appliance, turn it off, remove the plug from the plug point and wait
until it cools down.
• To ensure proper operation of the appliance, periodically check that the rear ventilation grille is
not blocked by fluff or threads: this should be done after removing the plug from the mains; If
necessary, use a vacuum cleaner, taking care not to damage the element.
• To clean the main outer casing using a soft, damp cloth; do not use steel wool or abrasive products.
"= hot air (1000W); "
14
"= very hot air (2000W)
Publicité
