Publicité
holes for the handle installation. The gasket is easily displaced by hand, no tools are necessary.
2) Install the handle tightly as shown above with two screws. Be caution; do not over tighten as it will cause
damage to the handle assembly or surface of glass door.
3) Replace the door gasket to its original position. Make sure it will be well positioned and maintains perfect
hermiticity.
Reversing the door
The door can be changed from left and right side. No special requirement, all the door is opened from left
side. If required to open from right side please refer to the following direction.
Note: all parts removed must be saved to do the reinstallation of door.
Remove the glass door by unscrewing the eight lock screws 3 and 4. Be careful to hold the glass door firmly
after removing the screws and place it on a padded surface to avoid the risk of damage.
Unscrew and transfer the door supporter 2 to the opposite side.
Rotate the glass door 180° and refit the glass door to the opposite side.
Then screw and tighten it after the door is leveled. Stick the light contactor opposite of 5 position, which
was packed together with the instruction manual and adjust the side fixing oppositely.
5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 10-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-
12°C/12-20°C.
Temperature setting
45
Publicité
