Publicité
For the installation of the cylinder proceed as follows:
1) Close the cylinder valve (4).
2) Check that the valve is closed the stove.
3) ENSURE THAT THERE IS A SEAL ON THE PRESSURE
REGULATOR AND THAT IT IS IN PERFECT CONDITIONS
BEFORE ATTACHING THE REGULATOR ON THE NEW GAS
CYLINDER.
4) Attach the regulator (1) to the cylinder.
5) Insert the rubber tube on the one hand on the receiver cooker (2) and the other on the pressure regulator
and secure with hose clamps (3).
6) WARNING: to avoid a dangerous overheating of the gas pipe, DO NOT install the hose by passing it
under or behind the stove but at the side, keeping it away from the cooking area
BEFORE USING CONTROLLED THAT THERE ARE NO LEAKS.
Never use an open flame to check for leaks, always use a solution of soap and water or our article 1726 Revel
Gas.
Check that the control knobs on the grill is closed (OFF).
Turn the tap on the gas bottle.
Apply solution of soap and water or ns. Article 1726 Revel gas in the tube and on all connections. If bubbles
appear, it means that there is a loss and it repaired before use.
After making the repair, repeat the test.
After conducting the test, close the gas supply to the tank.
If it is a leak is detected and you can not fix it, do not try to fix it another way, but instead use the assistance
service.
In the case of gas leaks immediately close the valve of the gas cylinder.
1) Check all the connections before using the appliance.
2) Never work with the rubber hose not securely fastened by means of the above mentioned metal clamps (3).
3) Do not use the appliance if it is leaking, deteriorated or malfunctioning.
4) Place the stove on a stable, horizontal, heating resistant and not flammable surface.
5) Place the stove at a safe distance from inflammable materials and from objects that are sensitive to heat.
6) Ensure that the tap (4) of the stove is CLOSED (clockwise rotation).
7) Open completely the tap of gas cylinder.
8) Turn clockwise the handwheel of the tap (4) to the maximum position.
9) For the models 104985 and 104986 (traditional ignition): bring a flame to the burner (1).
For the model 104986V (piezo-electric ignition): press the piezo ignition.
10) Make sure the burner is lit and regulate the flame according to your requirements.
11) If the flame is extinguished for any reason (blast of wind or spilled liquids), immediately close the taps of
the burner and the cylinder valve. Check the cause of the shutdown and restart if there are no problems
with the ignition process.
12) Place the pot upon the burner support, checking that it is in a stable position and the equipment is properly
balanced.
13) Ensure that the flame does not come out at the bottom of the pot large size.
14) Ensure that liquids do not come out off the pot and extinguish the flame.
15) Do not move the stove with working flame.
16) The body of the stove (base) may become hot during use. Handle exclusively using gloves.
1) Recommended diameter of the vessels.
2) ATTENTION: the maximum weight that the stove can support is 15 kg.
3) Place the pan directly on the grill, making sure it is in perfect balance.
4) Adjust the flame so as not to spill liquids into the pot, because they can switch off the burner.
DT Istr 104985-104986 – 02/2011 - Rev 9_04/2018
LEAKAGE TEST
FUNCTIONING
USE OF RECIPIENTS
TAP OPENING/CLOSING DIRECTION
OPEN
CLOSE
10/32
Publicité
