Publicité
• Use safety goggles and ear protection: Wear safety glasses with side shields when operating the tool and verify that others in the work area are also wearing
safety glasses. Always wear ear protection to help prevent hearing damage and loss.
DESCRIPTION OF MAIN PARTS (FIG. 1)
4
SPECIFICATIONS
AIR SYSTEM (FIG. 2)
• Always use clean, dry, regulated compressed air at 4 to 7 bar (60 to 100PSI).
• Do not exceed the maximum and minimum allowable pressure. Operating the tool at the wrong pressure (too low or too high) will cause excessive noise
and/or rapid wear.
• It is recommended that a filter-regulator-lubricator be used and be located as close to the tool as possible.
• If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic tool oil into the air inlet plug before each use.
• If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the air pressure to the tool, which will cause a reduction in power,
efficiency, and general performance.
• Ensure that all connections in the air supply system are sealed in order to prevent air from leaking. Failure to comply will result in injury or damage to
equipment.
• Always inspect the tool prior to each use to ensure that it is in good working order. Do not use the tool if it is damaged in any way or if any part is
malfunctioning.
• Only use accessories which are specifically designed for use with this tool.
• Drain the compressor tank daily. Water in the air supply line will damage the tool.
• Clean the air inlet and the filter weekly.
• Air pressure should be increased to compensate for unusually long air hoses. The hose diameter should be 3/8'' ID (inner diameter).
Fig. 1
Technical Data
Model
Speed
Quick connector
Air tool
Air hose
WWW.NIKOLAOUTOOLS.COM
1
2
3
BAT6110
25.000 rpm
Lubricator
Filter
Quick coupler
Air compressor
Regulator
(0 to 8.5 bar)
Fig. 2
1. Air inlet
2. Lock-off switch
3. Trigger
4. Grinding collet/chuck
Cut-off
valve
E N
3
Publicité
