Télécharger Imprimer la page

Greencut MIG-185 Manuel D'utilisation page 58

Publicité

58
BOX CONTENTS
This machine includes the following items which you will find inside the box:
-
1x Welder
-
1x Ground cable
-
1x Electrode clamp cable
-
1x Torch
-
1x Welding mask
-
1x Brush/brush
-
1x Bearing
-
2x Nozzles
-
1x Instruction manual
Carefully remove the product and accessories from the box. Make sure all the items listed in the above list are
present.
Inspect the product carefully to make sure it has not suffered any breakage or damage during transport.
Do not discard packaging materials until you have thoroughly inspected the product and used it satisfactorily.
ATTENTION: If any parts are missing or damaged, contact the Authorised Service Centre. Do not
use this product without having replaced the missing or damaged parts. Using this product with
damaged or missing parts can cause serious injury to the operator.
USE OF THE PRODUCT
WORKING PRINCIPLES
The operating principles of the welding machine are shown in the following figure. Single-phase with 220V AC
working frequency rectified to DC (350V); then converted to AC frequency (about 40KHz.) via the inverter device
(IGBT).
After reducing the voltage through the transformer (main transformer) and rectifying through the rectifier (fast
recovery diodes), inductance filtration is emitted.
The circuit adopts current feedback control technology to ensure stable current output when in MMA or TIG mode .
It also adopts voltage feedback control technology to ensure stable voltage output when in MIG mode.
The welding current parameter can be continuously and infinitely adjusted to meet the requirements of the welding
job.

Publicité

loading