PMS KTP EVO 2 Manuel D'utilisation page 18

from the results obtained in regulatory
tests, described in standard EN355. The
tests are carried out with a maximum
rated load claimed at 100 kg.
- Remember that in a fall prevention
system, only an EN361 fall prevention
harness can be used for retaining the body.
- The anchor point on the structure
where the fall prevention system will
be fi xed must be above the user, at a
reduced distance and must also meet
the minimum resistance requirements
required by standard EN795: 2012 (R ≥
1200 daN). Avoid deviating too far from
the balance of this anchorage in order to
limit the extent of a possible pendulum fall.
TRANSPORT / PACKAGING / STORAGE
- Transport in packaging and protected
from shocks or pressures due to the
environment.
- Use a waterproof, rot-proof protective
packaging
- Do not expose these products to
temperatures below -30°C or above +50°C.
- The product must be stored in a dry and
ventilated place, away from any source of
direct or indirect heat, and ultraviolet. The
INTERPRETATION OF THE MARKINGS (#6)
Harness KTP EVO (#6-A)
1 Ref : Product reference.
2 S/N: Serial number (Manufacturing
date – Manufacturing batch)
3
Pictogram requesting to read the
instructions before use.
4
Date of manufacture.
5 Expiry date.
6 Manufacturer's logo.
7 Product standard.
8 Manufacturer's address.
This product is compliant with Regulation 2016/425.
The declaration of conformity is available at: www.pms-ind.com.
APAVE SUD EUROPE SAS (N°0082) – CS 60193 – F13322 MARSEILLE CEDEX 16
AFNOR CERTIFICATION (N°0333) - 11, rue Francis de Pressensé - FR 93571 LA PLAINE SAINT DENIS Cedex
Notifi ed body for UE type examination :
Notifi ed body for production control :
18
drying of wet equipment must be carried
out under the same conditions.
MAINTENANCE
- Cleaning and disinfection: exclusively with
water and neutral soap.
- Any modifi cation or repair of the product
is prohibited.
- The equipment will be put back into
service only with a written agreement from
the manufacturer or the repair centre.
- If the equipment has sustained a fall, it
must be destroyed.
LIFESPAN
- PPE against falls is designed for
long years of operation under normal
conditions of use and maintenance. The
lifespan depends on the usage.
- Certain particularly
environments, salty, siliceous, chemical,
can reduce the lifespan of PPE. In these
cases, special attention must be paid to
protection and controls before use.
- The indicative lifespan of the products
recommended by the person responsible
for marketing is 10 (ten) years.
9 Identifi cation of the notifi ed body
that intervened in the inspection and
production phase.
10 CE Marking.
11 Maximum clearance (for KTP EVO 2,
KTP EVO 4 and KTP EVO 6).
12 Maximum lanyard length without
connectors (for KTP EVO 2, KTP EVO 4,
KTP EVO 6 and KTP EVO 11).
aggressive