Publicité
1. INTRODUCTION
Congratulations on your purchase of the
Philips Power Control System (SBC SK305).
This system contains one remote control (SBC
SR315) and one power switch (SBC SP370).
With the Power Remote Control system you
can operate electrical appliances (e.g. lamps,
coffee-maker etc.) in and around your house
via the remote control without getting out of
your chair!
2. QUICK REFERENCE
1. Install the enclosed batteries in the remote control (fig. 1) .
2. Connect the Power switch to a mains power outlet (fig. 2) .
3. Select the appliance, e.g. a lamp, you want to control and plug it into the
Power switch (fig. 2) .
• Check the power consumption of the selected appliance before
plugging it into the Power switch. The Power switch can control
appliances with a maximum power rating of 1000 Watts!
• If the selected appliance has its own ON/OFF switch, make sure they
are switched on.
4. Use the remote control to operate the appliance (fig. 3) .
The Power switch operates with button 1 as its default setting.
If the right side (+) of the button is pressed, the selected appliance
switches on. If the left side (-) of the button is pressed, the selected
appliance switches off again.
3. INSTALLATION
BATTERY INSTALLATION
Install the enclosed batteries in the remote
control as follows (fig. 1) :
• Unscrew the battery door at the rear the
remote control.
• Insert the batteries in the unit, checking
carefully that the battery polarities (+ and -)
match those inside the compartment.
4
SBCSK305page 4
Before connecting an appliance to the Power
Control System, please read this document
carefully.
QUICK REFERENCE
– Remove the batteries when the remote
control is not going to be used for a long
period of time.
– Batteries in the remote control should be
replaced once a year. If the transmission
range of the remote control reduces
drastically, batteries need to be replaced
immediately.
– Replace batteries only with original PHILIPS
8LR932 batteries.
Notes:
Publicité
