Télécharger Imprimer la page

HUUM HIVE Flow Mode D'emploi page 17

Poêle pour sauna

Publicité

ATTENTION!
before emptying the ash drawer into a fire resistent waste bucket or
combustible material container.
• Make sure there is a draft in the chimney. If in doubt, check the draft, by burning
some paper in the hearth of the sauna stove.
• The maximum quantity of firewood provided in Appendix 1 of the operation manual
should not be exceeded. The firewood should not be added to the hearth of the
sauna stove more often than the minimum intervals provided in Appendix 1.
In case of very dry and also fine firewood, the amount of heating material should
be reduced.
ATTENTION!
If the surface of the sauna stove turns red, it is overheating. In this case,
immediately close the air valve at the bottom of the stove to reduce the intensity of
the combustion. The manufacturer is not responsible for deformations and
damages of the sauna stove that have occurred as a result of overheating.
The firewood to be inserted to the hearth should be weighed at least for the first few
times of heating. Later, this process could be repeated from time to time, especially if
you change the length or type of firewood. An ordinary bathroom scale is suitable
for weighing firewood.
STARTING THE HEATING
The first batch should consist of medium-sized firewood and a small amount of fine
chips. The maximum quantity of firewood in kilograms has been provided in Appendix 1
• Lay the thinner firewood for the bottom layer.
• Put the thickest ones as the middle layer.
• Cover the middle layer with thin firewood with chips for kindling.
• Place the firewood as far back as possible in the hearth, leaving about
of free space between the firewood and the back wall.
• Lay the firewood tightly to the hearth, leaving air gaps between the firewood is
not necessary.
Ignition should take place from the upper quarter of the heating material.
It is convenient to use a fire starter (non-liquid) or birchbark for lighting.
ATTENTION!
Never light the fire from the bottom!
This causes burning that wastes fuel and pollutes the
environment. Also, both the stove and the chimney heat
up more slowly and the heating process takes longer.
• The air valve at the edge under the front part of the sauna stove should be
fully opened. If the draft in the chimney is too big and the burning is very intense,
the burning speed can be reduced by adjusting the air valve.
Ashes and coals should be completely extinguished and cooled
Make sure you don't overheat the sauna stove!
/₃₂" (10 mm)
13
17

Publicité

loading

Ce manuel est également adapté pour:

Hive flow lsHive flow miniHive flow mini ls