Max Input Power
Max Input Current
Rate Voltage
Hub 2000 controller doesn't include a battery pack, and the battery needs to be
purchased separately. For more information about battery AB1000 or AB2000 or
SuperBase V, please check the user manual of AB1000 or AB2000 or SuperBase V.
* This charging power can be upgraded to 960W with a firmware version
upgrade.
3. SAFETY INSTRUCTION
3.1 Usage
1. Please check whether SolarFlow is damaged, cracked, liquid leakage, heat or
other abnormalities or cables are damaged before operating. If any, please
stop using the product immediately and contact our customer service.
2. Keep a distance of 50mm between Hub 2000 and other objects.
3. During the operation of the solar energy system, avoid direct sunlight to
prevent the SolarFlow system from overheating. Do not place the SolarFlow
near any heat source.
4. Do not use around strong static electricity or magnetic fields.
5. It is prohibited to place the equipment in an environment with flammable,
explosive gas, or smoke. Since SolarFlow relies on the shell to dissipate heat,
over-temperature of the shell will lead to damage.
6. Do not attempt to replace the internal components of the equipment by any
unauthorized personnel.
7. Please install the product according to our user manual to avoid damage to
the product or injury to other people.
8. Ensure before finishing installation, the solar cable, the Microinverter cable
to home grid are disconnected.
9. Ensure that Hub 2000 and Microinverter are installed firmly to avoid
accidents and product damage caused by dropping.
10. SolarFlow has a protection level of IP65, so the product cannot be immersed
in liquids. If the product accidentally falls into water during use, please place
it in a safe and open area and keep it away until it is completely dry. The
dried product should not be used again and should be properly disposed of
according to the disposal guidelines in this manual.
11. Please ensure proper ventilation while in use, inadequate ventilation may
cause permanent damage to the equipment.
12. Do not place anything on the top of SolarFlow, please install it where people
cannot touch it.
13. Do not move or shake the unit while operating as vibrations and sudden
impacts may lead to poor connections to the hardware inside.
14. Case of fire, only a dry powder fire extinguisher is suitable for the product.
15. Only clean the ports with a dry cloth.
16. Keep out of reach of children and pets.
17. For safety purposes, please use only the original charger and cables
designed for the equipment. We are not liable for damage caused by third-
party equipment and may render your warranty invalid.
Output to SuperBase V
1800W
37.5A
45-58.4V
EN
3