Publicité
3.
The hook racks are pre-assembled on the back of the heater, hang the top two hook racks
on the screws as picture (3). Mark the two bottom hook racks' position on the wall and take
away the heater, then drill bottom two holes(Φ8) on the wall and put expansion screw's
plastic cover in the holes as picture (3).
4.
Hang the heater on the wall and put the expansion screws in the bottom two holes as
picture (4).
3.
FEET ASSEMBLY
1.
Fit the foot onto the bottom of
the body.
2. Fasten the foot with 4 screws.
Before starting the product, make sure that it is properly fixed to the wall. If the
4.
WARNING!
product is not level, problems may occur.
EN
21
Publicité
