Publicité
6. Starting up
6.1 On/Off switch (Fig. 10/Item 4)
To switch on the machine, press the On/Off switch
(4) the left.
To switch off the machine, press the On/Off switch
(4) to the tight.
Restart safeguard
If the battery is removed and reinserted in running
mode (e.g. when changing a battery), the tool
will not start up again automatically. To carry on
working, fi rst switch off the tool and then switch it
back on.
6.2 Speed controller (Fig. 10/Item 3)
The required speed can be set with the speed
controller (3).
•
Turn it clockwise to increase the speed.
•
Turn it counter-clockwise to reduce the
speed.
Important!
The correct speed depends on the tool used and
the type of material being processed.
6.3 Information on speed settings
•
Small cutters/grinding pins: High speed
•
Large cutters/grinding pins: Low speed
6.4 Practical tips
•
Exert only moderate pressure on the work-
piece so that it can be machined at constant
speed.
•
Instead of accelerating your work, high pres-
sure will cause the drive unit to slow down
and even stop, thus overloading the motor.
•
For your own safety, it is essential to secure
small workpieces with a screw clamp or vise.
•
Precision work/engraving: Hold the drive unit
like a pen (single-handed).
•
Rough work: Hold the drive unit like the hand-
le of a hammer (two-handed).
6.5 Description of the accessories
(Fig. 2+11-13)
Grinding pins (8):
In various grinding head shapes.
For grinding and deburring metal and plastic.
Recommended speed setting: 20-30*
Anl_TE_MT_18_34_Li_SPK13.indb 18
Anl_TE_MT_18_34_Li_SPK13.indb 18
GB
Cutting pins (9):
For cutting + engraving plastic, wood, soft metal
and glass.
Recommended speed setting: 10-25*
Pot brushes (10):
For cleaning stone, metal, aluminium, etc.
Recommended speed setting: 25-34*
Cutter (11):
For cutting plastic, wood and soft metal.
Recommended speed setting: 10-25*
Grinding/sanding belts (15):
For grinding/sanding wood and plastic.
See Fig. 11 for fi tting.
Recommended speed setting: 25-34*
Polishing wheels (16):
For polishing brass, tin, copper, etc.
Also for use with polishing pastes.
See Fig. 12 for fi tting.
Recommended speed setting: 15-25*
Cutting wheels (17/19):
For cutting metal and plastic.
Fasten the cutting wheel to the clamping spindle
(14). (see Fig. 13)
Recommended speed setting: 15-25*
Grinding wheel (18):
For cleaning and sharpening blades and tools.
Fasten the grinding wheel to the clamping spindle
(14). (see Fig. 13)
Recommended speed setting: 15-25*
Collet chuck key (20):
For mounting accessories.
Sleeves (21):
Various sizes for holding diff erent accessories.
*min
-1
x 1000
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
- 18 -
14.03.2023 11:08:30
14.03.2023 11:08:30
Publicité
