Publicité
ELECTRICAL CONNECTION
Before connecting the plug to the power outlet, make sure that the voltage of your electrical system
corresponds to the voltage shown on the appliance rating label and the outlet you are going to use is
in good condition.
INSTALLATION
The appliance may be used on any rigid horizontal surface. Do not overload the electrical circuit;
avoid using the same outlet for multiple appliances.
OPERATION AND USE
1. Connect the appliance to the power outlet.
2. The appliance emits a beep and the power indicator light (H) comes on and remains on as long
as the appliance is powered.
3. The appliance goes into STAND-BY and the display shows "- - ".
4. Press the ON/STAND-BY button (A) to turn on the appliance. It will begin to heat with the
predefined settings.
5. Press the MODE button (E) to select one of the following functions available:
Heating (
5.1 Heating (
In this operating mode you can set the desired temperature by pressing the + and - adjust-
ment buttons (B) and selecting one of the power levels: MIN, MAX, and AUTO using the
power selector button
MIN power level:
The appliance operates at the minimum power, reducing energy consumption to the mini-
mum.
MAX power level:
The appliance operates at the maximum power for rapid heating of the room.
AUTO power level:
The appliance automatically determines the operating power based on the ambient conditions.
5.2 Ventilation (
In this operating mode only the fan operates, so the appliance does not heat the room.
5.3 Anti-freeze (
In this operating mode the appliance keeps the room at a temperature of 45°F (7°C) to prevent
freezing temperatures.
6. If you want the appliance to distribute the airflow over a larger area, press the oscillation button
(C) (
). The appliance will then oscillate right and left. To stop the oscillation in the desired
position, just press oscillation button C again.
7. To turn off the appliance press the ON/STAND-BY button (A) and remove the plug from the outlet.
NOTE: The display can show the temperature in both °F and °C. To select, press and hold the + key
for at least 5 seconds, then release.
24-HOUR DIGITAL TIMER
This function can be activated from any operating mode.
Delayed switch-on: With the appliance in STAND-BY mode, press the timer button (F) (
The display shows the symbol
+ and - adjustment buttons (B), then wait a few seconds for the programming to be set.
The display returns to showing "--" for stand-by and the symbol
When the programmed time has been reached, the appliance turns on with the same settings it had
during the previous operation.
4
)
Ventilation (
)
(D).
)
)
and the time remaining before switch-on. To set the timer, use the
)
Anti-freeze (
to indicate you have set the timer.
)
).
Publicité
