Publicité
DOOR CONVERSION
If you need to hinge your door on the opposite side it is recommended that you call your local authorised
service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure
the appliance is unplugged and empty. After reversing the door, leave the appliance alone for 8 hours
before switching it on. This allows the coolant to set.
It is recommended to use a crosshead screwdriver, a socket driver and a flathead screwdriver (not
supplied).
1.
Remove the upper hinge cap (7).
2.
Remove the two screws (6) and
then remove the top hinge (5) that
holds the door in place. Lift the door
and place it on a padded surface to
prevent it from being scratched.
3.
Remove the plug (9) and transfer it to
the uncovered hole at the other side.
Be sure to press the button firmly
into the hole.
4.
Remove the two bolts (1) that hold
the lower hinge (2).
5.
Remove the adjustable foot (4)
from the other side of the bottom
and transfer it to the corresponding
position on the opposite side of the
bottom.
6.
Fix the lower hinge (2) and the adjustable foot (3) on the opposite side of the bottom.
7.
Carefully set the door back into place making sure the pin enters the bushing at the lower frame
section (hole).
8.
Insert the top hinge (5) back and screw it to the top of the appliance. Ensure the door is aligned
horizontally and vertically so that the seals are closed on all sides before finally tightening the
bottom hinge (2).
9.
Put the upper hinge cap (7) back.
10. With the door closed, check that the door is aligned horizontally and vertically and that the seals are
closed on all sides. Readjust the levelling feet as required.
www.domo-elektro.be
37
DO91910
Publicité
