Publicité
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed for all installations:
__——
=)
Flat-blade screwdriver
=eC—e
1/4" and 5/16" nut driver
Level
(recommended)
Tape measure
Pliers
Utility knife
Tin snips (new vent
installations)
qo
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Caulking gun and compound
(new vent installations)
Tools needed for gas installations:
e——— fy)
U G
8" or 10" pipe wrench
8" or 10" adjustable wrench
(for gas connections)
Pipe-joint compound
resistant to LP gas
Parts supplied:
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
"Y¥" connector
e—
Long inlet hose
Short inlet hose
Rubber washers
Parts needed: (Not supplied with dryer)
@ Vent clamps
m@ Vent elbows and ductwork
Additional parts may be required, depending in your installation.
Check local codes. Check existing electrical supply and venting.
Read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Publicité
