Publicité
9001629
4.
Remove the jack once the load is on the ground or a support
mechanism like jack stands.
5.
The ram should fully retract. If it does not, push down on it until it
is seated.
RAISING AND LOWERING A VEHICLE
Take these additional steps before following instructions in
Lowering a Load
and
1.
Set the vehicle in parking gear and engage the parking brake.
a.
For vehicles with a manual transmission, engage the parking
brake and leave the car in reverse or 1st gear. Consult your vehicle
owner' s manual for the correct gear.
2.
Place wheel chocks that fit the wheel curve on either side of the
vehicle' s remaining wheels.
3.
Place the jack only on support points or areas specified by the vehicle
manufacturer (consult owner' s manual).
4.
Lift the vehicle to a height that leaves enough room to place the
jack stands.
5.
When the work is done, raise the load enough with the jack to
carefully remove the jack stands.
6.
Slowly and carefully lower the load.
CARE & MAINTENANCE
WARNING! Do not loosen or remove the Safety Valve Cover Screws (I). The
safety valve setting is preset. Changing the valve setting can cause a jack to
fail, resulting a serious injury if the load falls.
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts
when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Keep the tool handles clean, dry and free from oil/grease at all times.
5.
Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
8
3 Ton Quick-Lift Floor Jack
.
For technical questions call 1-800-665-8685
V1.0
Raising a Load
Publicité
