Publicité
HPW 140 EASY
DANGER! When using detergents, the material
data safety sheet issued by the detergent manufac-
turer must be adhered, especially the instructions
regarding personal protective equipment.
Remove the cap of the clean detergent bottle (L).
Gently pull the on board detergent tank out of its
storage position.
Fill the tank with detergent designed specifically
for use with pressure washers.
Assemble the lance with adjustable spray nozzle on
the trigger gun and rotate the nozzle on the posi-
tion for use with detergent (M).
RECOMMENDED CLEANING METHOD
Spray the detergent sparingly on the dry surface
f
and allow it to react, but not to dry.
Rotate the nozzle and wash to remove the deter-
f
gent.
AFTER OPERATION WITH DETERGENT
Drain and wash out the detergent tank at the end
of the working session. To wash out the tank use
clean water instead of the detergent.
FINISH OPERATION
Release the lever of the trigger gun.
f
Turn off the appliance " ON/OFF".
f
Disconnect the mains plug from the socket.
f
Only separate the high-pressure hose from the trig-
ger gun or the device when there is no pressure in
the system.
ATTENTION!
Pressure the lever of the trigger gun to release
ƒ
any remaining pressure in the system.
Release the lever of the trigger gun.
ƒ
Lock the lever of the trigger gun (N).
ƒ
Beware that when disconnecting the supply or
ƒ
high pressure hose, the hose is filled with water.
Detach the appliance from the water supply.
ƒ
MAINTENANCE AND SERVICE
Stop, remove plug from the power supply and dis-
connect from water supply.
Note: To ensure long and reliable service, carry
out the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance
or repairs before using.
If the replacement of the supply cord is necessary,
this has to be done by FF GROUP or an authorized
FF GROUP service agent in order to avoid a safety
hazard.
CLEAN THE WATER FILTER/NOZZLE REGULARLY
The water filter must not be damaged.
f
Pull the sieve out (O)
f
Clean the sieve under running water.
f
Reinsert the sieve into the water filter and assem-
f
ble the filter on the machine.
Clean the nozzle with the needle clean-out tool
f
provided. Remove the spray lance from the gun.
Remove any dirt from the nozzle hole and rinse (P).
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as
waste. Machine, accessories and packaging
should be sorted for environment - friendly recy-
cling. The plastic components are labeled for cat-
egorized recycling.
WARRANTY
This product is warranted in accordance with the
legal/country specific regulations, effective from
the date of purchase by the first user. Damage
attributable to normal wear and tear, overload or
improper handling will be excluded from the guar-
antee. In case of a claim, please send the machine,
completely assembled, to your dealer or the ser-
vice Centre for electric power tools.
English |
19
www.ffgroup-tools.com
Publicité
