Presettings; Changing Presettings With The Control Panel - ergoline EXCELLENCE 880 TURBO POWER VHP12 Instructions De Service

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Changing presettings with the control panel

The setting mode enables you to call up operating states and make alte-
rations to current settings. If VoiceGuide is included with the device, you
can also listen to the explanations on the preadjustments.
Changing to Presetting mode
• Press the buttons - and + simultaneously for at least five seconds out-
side a tanning process.
appears in the display.
• Enter the code (see Page 81).
• Press the START/STOP button four times when you run the Preset-
ting mode for the first time.
briefly appears in the display, then
and the presetting value are displayed alternately (see column "On
delivery").
• By pressing the + button you scroll up to the next function (from -01-
to -36-).
• By pressing the – button you scroll down to the next function (from
-36- to -01-).
80
Changing presettings
Increase the preset value:
• Press and hold the START/STOP button while simultaneously pres-
sing the + button.
Decrease the preset value:
• Press and hold the START/STOP button while simultaneously pres-
sing the – button.
Reset to the last value set:
• Press the START/STOP button.
Reset to the delivered state:
• See function
(Function 1)
Note:
The sunbed will automatically return to 'idle' mode 30 se-
conds after the last button was pressed.
Note:
The majority of the pre-settings can be set up to meet your
individual needs in pre-setting mode. The settings for cer-
tain functions have already been entered by the system as
default settings and cannot be changed!
The presettings are listed beginning on Page 83.
.

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour ergoline EXCELLENCE 880 TURBO POWER VHP12

Table des Matières