Tanning
Start and end of tanning
The device is started automatically with an internal or external timer and
automatically stopped after the preselected time. The fan continues to
run for approx. 3 minutes (fan delay) to sufficiently cool the device.
Note:
Timer instructions: see separate manual.
Preparation time
Before the UV lamps automatically go on, you have a few minutes to pre-
pare yourself. During the preparation time you can switch on the UV
lamps at any time by pressing the START/STOP button.
– Remove your clothes and all jewelry.
– Remove make-up and other cosmetics.
– Remove glasses. Contact lenses can be worn under the protective
goggles.
– Put on the protective goggles.
– Lie down on the bed surface.
– Close the canopy.
Depending on the controller, the tanning device starts up after a short
time automatically. The tanning device is operating when the UV lamps
are on and the fans are running.
26
If the device fails to start up when you have closed the canopy:
– Press START/STOP to start tanning.
07272 / 0