Télécharger Imprimer la page

LA NORDICA TERMOROSSELLA PLUS EVO DSA 4.0 Manuel Utilisateur page 30

Publicité

DESCRIPTION
De nition: thermo-product according to EN 13240.
La NORDICA thermoheating products are ideal for holiday ats and weekend houses or as auxiliary heating all year round.
WOODEN LOGS ARE USED AS FUEL. THE APPLIANCE WORKS AS AN INTERMITTENT OPERATING APPLIANCE.
The appliance is composed of painted and galvanised sheet steel and cast iron. The replace is found inside the boiler, is built in 5 mm thick
steel and is reinforced using welded nails. A swivelling, removable grid is found inside the replace. The water in the heating system circulates
in the boiler, which absorbs the heat produced in the replace.
The ceramic glass window (resistant up to 700°C) of the door provides a lovely view of the burning ames and prevents sparks and smoke
from getting out.
ACCESSORIES
ROOM HEATING TAKES PLACE:
A
BY RADIATION: the heat is radiated into the environment through the panoramic window and the hot external surfaces of the
thermo-product;
B
BY CONDUCTION: radiators or heat convectors of the centralised system fed by hot water produced by the boiler (See chapter
CALCULATION OF THE THERMAL POWER).
THE DEVICE IS EQUIPPED WITH REGISTERS FOR PRIMARY AND SECONDARY AIR AND A THERMOSTAT WITH WHICH THE COMBUSTION AIR
IS REGULATED.
1A - PRIMARY Air Register / AUTOMATIC Thermostat
The thermostat has the task of automatically increasing or decreasing combustion.
Dependent on the position chosen, the thermostat will act on the valve which regulates the intake of air into the furnace, placed on the
back of the cooker. Turn it in a clockwise direction from 0 to 5 to make up the re and in an anti-clockwise direction to reduce combustion.
AS THIS IS AN EXTREMELY PRECISE DEVICE, IT IS ADVISABLE TO TURN IT CAREFULLY AND NEVER FORCE THE KNOB.
2A - SECONDARY air register
Over the door of the hearth there is the secondary air control.This regulator must be open (the lever must be moved to the right), especially
for wood combustion, so that un-burnt carbon does not undergo a post-combustion. Through this register it is possible to adjust the
power of the stove. Leaving it slightly open, according to the ue of the chimney, it is possible to keep the glass clean.
For a better comfort and corresponding oxygenation of environment, the air can be directly withdrawn at the outside. In
order to do that, the stove can be connected to the external air socket by an junction
AERATION OF THE INSTALLATION PREMISES).
The register regulation necessary in order to obtain NOMINAL CALORIFIC OUTPUT is the following (see Cap. NORMAL OPERATION):
TO IGNITE THE FLAME follow the instructions below (see Cap. IGNITION) :
• Open the butter y valve placed on the ue gas exhaust pipe must also be opened.
• Position the thermostat knob on position 5 (maximum opening).
• After having started the re with small pieces of wood and waited until it is well lit, adjust the thermostat to the positions corresponding
to the desired heat (0÷5).
• Close the butter y valve placed on the ue gas exhaust pipe must also be opened.
POKER
SERIES
(Picture
(Picture
6)
PRIMARY air
POS.0
RING air fitting ventilation additional
GLOVE
SERIES
6)
SECONDARY air
OPENED
ENGLISH
OPTIONAL
Picture 10
Picture 10
(see Chap. VENTILATION AND
TERTIARY air
PRE-ADJUSTED
11

Publicité

loading

Ce manuel est également adapté pour:

Termorossella plus forno dsa 4.0Termonicoletta evo dsa 4.0Termonicoletta forno dsa 4.0