Publicité
6
Ø3.5*14mm
Ø4*30mm
11
X2 set
We have included a set of tipping restraint hardware for this unit.
You must install this hardware to prevent accidents or injuries that
can result from the unit falling.
When properly installed, this restraint can provide protection against
the unexpected tipping of the unit due to small tremors, bumps or
climbing. We strongly recommend mounting this hardware to a wall
stud and your unit.
NOTE: The tipping restraint hardware included is for wooden
stud wall construction. It must be attached to a wall stud.
Depending upon your wall construction, different anchor
hardware may be required. Please contact your local hardware
store for assistance. Young children can be seriously injured
by tipping furniture. You must install the tipping restraint
hardware with the unit to prevent the unit from tipping, causing
any accidents or damage. The tipping restraints are intended
only as a deterrent and are not a substitute for proper adult
supervision. The tipping restraints are not earthquake
restraints. If you wish to add the extra security of earthquake
restraints, they must be purchased and installed separately.
14
Install the tipping restraint hardware
EN
1
3
WALL
Use short screws to fix the
device on the back of the
board (A) .
WALL
2
Make marks
on the wall.
WALL
4
Put two anchors
in the holes.
5
WALL
Drill two φ6 holes
in the wall.
Fix the device on
the wall with long
screws.
6
WALL
15
Publicité
