Publicité
m
Maintenance
IMPORTANT: Disconnect the cabin's power supply cable before undertaking any work.
Problems identified
No indicator light displayed on
the control panel.
One or more infrared panels do
not heat up.
Sauna gives off a smell.
A speaker is not working.
Screen shows a wrong
temperature.
Servicing
1. Disconnect your sauna.
2. Use a vacuum cleaner to remove dust from crevices in the woodwork.
3. Clean the cabin with a damp cotton cloth and use a small amount of soap if necessary. Rinse with a
damp cloth.
4. Clean the glass with a window / glass cleaner and a soft colth.
5. Please check and fasten the screws of the bench once every three months to prevent the play or fall
of the seat.
6. For the stove: Replace the stones when they crumble and/or when the performance of the stove
(approximately every 2 years).
IMPORTANT: Do not use benzene, alcohol, chemical agents or strong detergents on the sauna since
chemical products can damage the wood. Do not spray water on your sauna.
30
AintenAnce
Possible reasons
Power supply cable
disconnected.
The general power supply is
cut.
Fault in power supply unit.
The infrared panel button is
positioned to the middle (
The infrared panel's cable is
disconnected.
One of the infrared panels is
defective.
Temperature of the panels or
their cables is too high.
Speaker cable disconnected.
Speaker defective.
Temperature sensor is
incorrectly connected or
defective.
&
servicing
Check power supply cable
connection.
Check that the switchboard and
wall plug are working.
Contact your dealer.
Push the button panel to the right
or left according to your desire.
).
Check cable connections.
Replace the infrared panel with an
original component supplied by
the manufacturer.
Switch off power supply and
contact your dealer.
Reconnect the cable.
Contact your dealer.
Reconnect the cable or replace
the sensor.
Solutions
Publicité
