Controls Of Your Beverage Center; Setting The Temperature - Danby Designer DBC93BLSDD Guide D'utilisation Et Soins De Propriètaire

CONTROLS OF YOUR
BEVERAGE CENTER
To start the beverage center, turn the temperature con-
trol to the position corresponding to your desired cooling
level. The beverage center temperature will vary
depending on the quantity of bottles stored, and on the
frequency with which the door is opened.

SETTING THE TEMPERATURE:

The temperature of the beverage center compartment is
controlled by adjusting/setting the thermostat control
knob, located on the exterior rear wall of the unit. To
start the beverage center and achieve maximum cooling
quickly;
• Turn the temperature control knob clockwise to the
furthest (maximum) setting on the darker blue (wide)
section of the graduated control dial.
• Allow the unit to run at this setting for 3-4 hours.
• When maximum cooling is achieved, turn back the
temperature control knob to a desired setting on the
graduated blue control dial. See Fig.1.
• To turn off the beverage center (no cooling) rotate the
control knob to the "0" (off) position. See Fig. 2. Turn
the control to the "OFF" (0) position to temporarily
disconnect the cooling cycle. When the beverage
center is not to be used for long periods of time,
disconnect from power and leave the door partially
open.
Fig. 1
NOTE: Wait 3 to 5 minutes before restarting if operation
has been interrupted.
Interior Light:
To manually operate the light, depress the interior light
toggle switch situated on the left side of the interior light
housing, located on the ceiling inside the unit; this will
allow the interior light to remain on while the door is
closed.
OPERATING INSTRUCTIONS
Fig. 2
DEFROSTING: Your beverage center is designed
with an "Auto-Cycle" defrost system.What is Auto
Cycle defrost?
The refrigerated surfaces of the fresh food compartment
defrost automatically during the "off" cycle of the cold
control (thermostat). Defrost water from the fresh food
compartment is disposed of automatically, by means of
being channeled onto a drip tray located on the com-
pressor. Heat transfer from the compressor causes the
defrost water to evaporate.
6