Bestway 58462 Manuel De L'utilisateur page 5

• Pay attention to position of pool and pump so adequate ventilation, drainage, and access
for cleaning is available. Never place pump in an area that may accumulate water, or in
an area where foot traffic will flow around the pool.
• Atmospheric conditions may affect the performance and life span of your filter pump.
Unnecessary wear and tear may occur during periods of cold, heat and exposure to sun.
Whenever possible, shelter the pump from these conditions. It is important to ensure the
factory equipped stopper plugs for the inlet and outlet ports replace the screens before
removal or maintenance on the pump is attempted.
• Do not add chemicals in the filter pump.
• Don't plug or unplug the appliance if your hand is wet.
• Always unplug the appliance: on raining days, before cleaning or other maintenance and
leave it unattended on holidays.
• Read the instructions before using the appliance and installation/reassembly every time.
• In case of doubt on the pump or any circulation devices, contact a qualified installer, or
the manufacturer/importer/distributor.
• Mind all the safety requirements and recommendations described in the manual.
• This product is not intended for commercial use.
SETUP
CHECK LIST
To check the parts included in the box, consult the part list inside this manual. Verify that the equipment components represent
the model that you had intended to purchase. In case of any damaged or missing parts at the time of purchase, visit our website
bestwaycorp.com/support.
INSTALLATION
• For the installation instruction refer to the illustration steps
actual product. Not to scale.
• Bestway will not be responsible for any damage caused to the Skimatic Filter Pump due to mishandling or failure to follow
these instructions.
• It is imperative to check that the hydraulic connectors are not obstructed.
• Do not dry run the Skimatic Filter Pump. Make sure both the pool's inlet and outlet valves are fully covered by water
before operating the Skimatic Filter Pump.
MAINTENANCE
• Make sure that the Skimatic Filter Pump is unplugged before any maintenance.
• For the maintenance instruction refer to illustration steps
May not reflect actual product. Not to scale.
• To optimize the Skimatic Filter Pump performance and for sanitary reasons, we suggest replacing the filter cartridge with
a new one every two weeks.
STORAGE
• Remove all accessories; be sure that Skimatic Filter Pump is completely clean and dry before the storage. If all the parts
are not completely dry, mold may result.
• Before storage, remove and dispose of the filter cartridge.
• We strongly recommend disassembling the Skimatic Filter Pump when the environment temperature is below 10ºC / 50ºF.
• Store the Skimatic Filter Pump in a dry place with a moderate temperature between 10ºC / 50ºF and 38ºC / 100ºF.
WARRANTY TERMS
For information concerning warranty terms, visit our website at: www.bestwaycorp.com.
. Drawings are for illustration purposes only. May not reflect
inside this manual. Drawings are for illustration purposes only.
5