Publicité
3. Place the power supply (4) onto the wheel cart so that the front feet of the power supply are over the casters (3).
Center the power supply on the rails. Wheel kit 229467 has two positioning labels on the wheel kit frame. (See the
figures on the previous page.) The starting line on the label should be flush with, or just covered by, the corner on
the front panel of the power supply.
4. Hold the cart and pull the rear locking mechanism handle (2) toward the rear of the cart until the mechanism stops.
The locking mechanism pulls the power supply to the rear of the cart until the front and rear feet of the power supply
engage the front and rear tabs of the locking mechanism.
5. Insert the locking pin (1) through the rear locking mechanism handle (2) and into the wheel cart frame until the pin is
fully seated in the frame.
6. Carefully lift the power supply handles (5) to verify that the power supply is securely attached to the front and rear of
the cart. If the power supply is not secured to the cart, repeat the procedure.
The power supply is locked into place. You can position the Powermax by lifting the front handle and rolling the
system on the rear wheels of the cart.
7. Press the brake pedal (6) down on both casters to prevent the power supply from rolling.
Power supply
rear panel
Field Service Bulletin
All manuals and user guides at all-guides.com
5
1
2
Wheel Kit OperatiOn
Power supply
front panel
4
6
3
3
Publicité
