Power Connection; How To Charge The Transmitter - Beyerdynamic WA-CD Mode D'emploi

WA-CD – Charging Unit

6. Power connection

• Mount the appropriate power plug to the power adaptor.
• Connect the power adaptor to the charger and to the mains.
• The charger provides no separate on/off switch and will start up automatically.
• The charging lights of the battery compartments will illuminate white to indicate the ready operating status of
the device.

7. How to charge the transmitter

• Put the handheld or beltpack transmitter or the NiMH batteries in the charging compartments as indicated in the
drawing. If the transmitter is turned on, it will be turned off automatically.
Make sure to insert the NiMH batteries into the charging compartments as indicated by the +/- marks.
Important: Before charging please make sure that there are not non-rechargeable alkaline batteries in the
transmitter. The simultaneous of different batteries (alkaline and NiMH) in one transmitter is not suitable for
operating the transmitter, furthermore these transmitters should not be charged, because transmitter and charger
could be damaged. In this case the guarantee will be invalidated.
• Before charging the device performs a so-called cell type detection. Even after the start of charging another
security mechanism checks the first minute of charging, if the transmitter is equipped with rechargeable batteries.
If there are no rechargeable batteries inside the transmitter, the charging process is not started or interrupted and
the error is displayed by flashing red.
Beltpack transmitter
(with NiMH batteries)
Note: In the picture you can see the Quinta TH handheld transmitter and the TG 1000 Beltpack transmitter.
Instead of the Quinta TH you can also recharge the TG 1000 handheld transmitter.
Handheld transmitter
(with NiMH batteries)
NiMH batteries
WA-CD charger
12