Synexis C10
Safety instructions:
• Never charge a beltpack receiver or beltpack transmitter when they are powered
with normal batteries!
• Make sure that the ambient temperature does not exceed 45 °C (113 °F); if necessary ensure
an additional ventilation.
• Despite the Auto-Off function we recommend turning off the receivers and transmitters
before charging!
• After a power failure or after the receiver and/or transmitter has been reinserted, the entire
charging process begins again. Overcharging is prevented however.
• If you use the transmitter and receiver from time to time only, we recommend to recharge
these devices every 2 or 3 months to avoid the rechargeable batteries being over-discharged
due to self-discharge.
• Do not cover the ventilation slots of the Synexis C10 charger.
3. Power supply
•
Connect the Synexis C10 charger to AC power
•
The charger has no separate on/off switch and is ready for operation when it is connected to AC
power.
•
You can link a maximum of 6 chargers by connecting the first charger via the connection
the connection
connection
to AC power.
4. Charging
•
Put the beltpack receivers / transmitters into the appropriate charging compartments
audibly click into place.
•
The charging process starts automatically.
•
The LED of the beltpack receiver and transmitter indicates the charging state of the batteries.
LED is flashing blue:
LED illuminates blue:
LED is flashing red:
5. Maintenance
•
For maintenance and cleaning disconnect the charger from AC power.
•
In order to ensure a perfect function, keep the contacts in the charging compartments clean.
•
Clean the charger with a dry cloth only.
•
When the housing or the power cable is damaged, the charger must not be put into operation.
of the second charger and then connect the second charger via the mains
The batteries are being charged
The batteries are fully charged
Error (no or defective rechargeable batteries or
accidental attempt to charge alkaline batteries)
.
7
to
until they