Publicité
CLEANING AND CARE
Replace the dust bag
Before replacing the dust bag, remove the power cord plug from the
wall outlet. Always use the vacuum cleaner with a fitted dust bag.
If you forget to insert a dust bag or it is fitted incorrectly, the cover
cannot be closed completely align the position of a dust bag and
close the cover
•
After disconnecting flexible hose, open the front cover by lift-
ing it upwards.
•
Release the dust bag lock and remove the bag from the
guides, if filled with dust.
•
Insert an empty or new dust bag by sliding it into the guides.
•
Close the cover by pressing it down until it clicks.
Clean and replace the inlet filter
•
Before cleaning the filter, remove the power cord plug from
the wall outlet.
•
The filter shall be cleaned when there are visible stains on it,
wash the filter in warm water with no detergent. Use it only
when completely dry.
•
Always use the vacuum cleaner with a filter in place.
•
Failure to install the filter may result in motor damage.
1. Remove the dust bag.
2. Remove the filter by sliding it out of the guides upwards.
3. Clean the filter or replace with a new one.
4. Reinstall the filter by placing it back into the guides. Ensure the
filter is completely dry before inserting it.
If the dust bag full indicator comes on, check whether the suction
brush, hose or tube is blocked with large items stopping the air flow.
After removing the items, if present, restart the vacuum cleaner if
the dust bag full indicator is still red, replace the dust bag with a
new one.
Note! Figures are for illustrative purposes only Individual models
may vary.
EN
Clean and replace the EPA12 exhaust filter
•
Before cleaning the filter, remove the power cord plug from
the wall outlet.
•
Clean the filter when it is clearly soiled. Shake dirt off the fil-
ter and then brush it with a soft bristle brush. Then rinse the
filter in lukewarm water and do not use any detergent. Do
not direct strong jet of water onto the filter. Use it only when
completely dry. If the filter is too dirty or damaged replace the
filter with a new one.
•
Depending on the intensity of use, it is recommended that
you clean the filter once a month and replace it with a new
one every six months.
•
Always use the vacuum cleaner with a filter in place.
•
It is recommended that you only use original Amica filters for
your vacuum cleaner.
1. Open the air exhaust cover.
2. Remove the filter, clean it or replace it with a new one.
3. Close the air exhaust cover.
Cleaning filters
Rinse the filter with warm water and let dry completely.
In the event of any fault:
•
Turn off the appliance:
•
Unplug the appliance from power
•
By following the instructions given in the table below, you can
correct some minor issues. Please check all points in the table
before you refer the repair to customer service.
8
Publicité
