Publicité
Maintenance and Service of your ES Series Freezer
All laboratory freezers require manual. In certain conditions (e.g. when the freezer is very full or
when any new items are stored in the freezer) frost may form on the rear wall as the compressor
must run for long periods of time.
Before manually defrosting the cabinet, make sure the power lead is disconnected from the
mains. Any loose frost found on the evaporator can be removed carefully using a wooden or
plastic scrapper.
WARNING: Do not use any knives or sharp metallic objects to remove frost.
Alternatively a non-scheduled defrost can sometimes be carried out as follows:
Function
To carry out a non‐scheduled defrost
N.B. This does not replace the automatic defrost function on relevant models
• Your freezer should be cleaned regularly.
• Before cleaning you MUST switch off and disconnect your freezer from the power
supply.
• The whole freezer except the door gasket can be cleaned with mild cleaning detergent.
• The door gasket should be cleaned with water only and wiped dry.
• The handle should be cleaned regularly with soap and water.
• Remove shelves/basket/door furniture and wipe with a soft cloth. DO NOT put then in a
dishwasher.
• Detergents containing abrasives or acids are not suitable for the cleaning.
• When all cleaning has been completed and accessories replaced, reconnect the plug with
dry hands.
Defrosting
Press
followed by
followed by
followed by
Cleaning
Hold button(s)
Example screen
down for
3 seconds
Four times
1 second
1 second
12
Publicité
