Publicité
4
WARNING: This assembly step is ONLY necessary for vehicles WITH a
dual-clutch transmission (DCT)!
Loosen the cable adjuster a few turns.
Install the spacer plate (15) between the brake lever and the parking brake
sensor.
Check whether the spacer plate (15) comes into contact with the parking
brake sensor.
Tighten the screw as specified in the mounting instructions.
Finally, place the cable adjuster in the desired position and secure it.
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
7
1
15
×
1
16
×
8 Nm
1
17
×
1
18
×
Errors and omissions excepted
Subject to technical and design changes.
Publicité
