Publicité
2
Remove the original end weights and handguards if mounted.
Make sure the handlebar ends and the inside of the handlebars are clear.
Loosely screw the parts shown to the brackets (7/8) as shown in the drawing
above.
WARNING: Use a liquid threadlocker!
Only tighten the screws (9) loosely.
Install the brackets (7/8) on the handlebar ends as shown in the drawing
below.
To do this, tighten the screw (9) enough so that the brackets (7/8) can still be
readjusted.
The content translation is automated.
© SW-MOTECH GmbH & Co. KG
MOUNTING STEP · READ AND KEEP MOUNTING INSTRUCTIONS!
5
2
6
×
M
18 Nm
1
7
×
1
8
×
2
9
×
M
18 Nm
2
10
×
2
11
×
Errors and omissions excepted
Subject to technical and design changes.
Publicité
